Answer of your leaving message
Light is solid blue. Will not reset. Last time this happened I was given a url to a file on drop box that i used to get it going again. i found the post but the file is gone now. Why did you take it down? Is there an update file. Please help.

by Scott Wilson

Dear Scott, thank you for contacting.

Always try the hardware reset and reinstall first.
Reset and Reinstallation ( delete the camera by the app sliding toolbar ‘Delete’ first )

If above does not help, and the front blue light (power) is still on, then, ( if blue is not on, meaning power is not through, defective )
We may try the firmware update manually :

A. Please must use this tool to format the SD card on PC
Rebuild the firmware from the external SD card :
This is a manual re-build firmware procedure for your reference
(recovery and cure rate is more than 90% )

Download file [PC]
- Uncompress/unzip it to root directory of a MicroSD card [PC->SD]
- Insert the card to iCam or iBabi
- Plug power cord of it. CAM will auto detect the codes in the Card
to do the update ( blue light is on )
D. Auto motor calibration/rotation (About 40~50 seconds)
- Wait till front blue led is blinking. (About 2-3 minutes)
- Unplug power cord
- Take card out.
- Plug power cord again and the blue led will keep blink ( waiting for installation )

Installation: / If you are successful, please erase the card for normal use.

PS – this is what you see during the process
Insert the card with unzipped files
Plug in power
Short beep ( camera detect and read the files ) in 5 seconds
After about 40 seconds
Two short beeps ( writing complete )
Blue and Green lights blinking – done ( wrote in )
Unplug the power
Remove the SD and erase it