Answer of your leaving message
I need the firmware cause after the reset the camera does not go on following the steps described on the manual.
this link is not working
https://www.dropbox.com/s/nm6l8qckst66ih3/icampro_362.zip?dl=0

by ALBERTO


Dear ALBERTO, thank you for contacting. Here it is.

Manual firmware rebuilding ( blue light (power) must be on )

A. Please must use this tool to format the SD card on PC
https://www.sdcard.org/downloads/formatter_4/index.html
B.
Rebuild the firmware from the external SD card : 
This is a manual re-build firmware procedure for your reference
(recovery and cure rate is more than 90% )
Download file
https://www.dropbox.com/s/w56gi1vzslm4781/icampro_362.zip?dl=0 [PC]
C.
- Uncompress/unzip it to root directory of a MicroSD card [PC->SD]
- Insert the card to iCam or iBabi
- Plug power cord of it. CAM will auto detect the codes in the Card
to do the update ( blue light is on )
D. Auto motor calibration/rotation (About 40~50 seconds)
- Wait till front blue led is blinking. (About 2-3 minutes)
- Unplug power cord
- Take card out.
- Plug power cord again and the blue led will keep blink ( waiting for installation )

Installation: https://www.youtube.com/watch?v=V-j_OzXsANo / If you are successful, please erase the card for normal use.

PS – this is what you see during the process
Insert the card with unzipped files
Plug in power
Short beep ( camera detect and read the files ) in 5 seconds
After about 40 seconds
Two short beeps ( writing complete )
Blue and Green lights blinking – done ( wrote in )
Unplug the power
Remove the SD and erase it